1. Unroll and position Texsalon Refuerzo horizontally at the base of a parapet wall or curb. Locate the tab with fastener markings toward the wall and the pre-applied tape toward the field of the roof and facing upwards.
2. Position Piranha Plates 3 to 19 mm from the angle change and 300 mm on center maximum and secure with HP-X Fasteners and Piranha Plates. Membrane must be fastened on the horizontal. Do not fasten plates over top of the release liner as this will cause the liner to tear when removed.
3. Remove any dirt or dust resulting from plate installation. Any residual dust/dirt will be detrimental to the bond strength of the tape adhesive.
4. Position deck membrane and thoroughly clean the underside of the deck membrane using Weathered Membrane Cleaner if necessary. (The entire surface where the tape is to contact must be clean. The adhesive on the Texsalon Refuerzo will not adhere to dusted / dirty surfaces).
5. Roller apply HP-250 Primer or LV-600 Primer to the underside of the deck membrane in the area that will come in contact with the 3” wide tape. The properly primed area will be uniform in color without streaks and free from globs or puddles.
6. Remove the release liner from the adhesive tape on the Texsalon Refuerzo pulling it parallel to the roof deck.
7. Roll the deck membrane onto the exposed adhesive tape and apply hand pressure to the splice area.
8. Pull the membrane back to expose the unadhered portion of the Texsalon Refuerzo. Apply Sure-Weld Bonding Adhesive or Sure-Weld Low VOC Bonding Adhesive to the deck membrane, exposed Texsalon Refuerzo and parapet wall.
9. Once the adhesive has dried, roll membrane to the angle change and crease. (Take extra care in creasing TPO membrane into the angle change to achieve desirable appearance). Roll the membrane up the wall and broom for 100% adhesion.
10. Roll the entire 150 mm width of the Texsalon Refuerzo splice area with a 50 mm wide roller using positive pressure.
11. To achieve proper adhesion of the Texsalon Refuerzo when job site temperatures fall below 5 ºC, heat the cleaned / primed area of the membrane with a hot air gun as the flashing is applied and pressed into place.
* General properties. Typical properties and characteristics are based on samples tested and are not guaranteed for all samples of this product. This data and information is intended as a guide and does not reflect the specification range for any particular property of this product.
|
 |
Vinitex Desagüe + Paragravillas
(PDF) Download Print version