Sure-Seal Pourable Sealer is a two-component, solvent-free, polyurethane-based product compatible with Carlisle's Sure-Seal and Sure-White ™ membranes. It is a material designed to provide a flexible, durable and long lasting seal around hard-to-flash penetrations in Sure-Seal and Sure-White Roofing Systems. The product can also be used to provide a permanent tie-in between the Sure-Seal and Sure-White membranes and a built-up roof surface and for attaching lightning rod bases and ground cable clips to the membrane surface.

Thoroughly mix Part B (1 pint can) and pour contents into Part A (1 gallon pail). Thoroughly stir components together using a variable speed drill and mixing blade for a minimum of 5 minutes. Be sure to scrape bottom and sides of the can to ensure uniform mixing.
Note: When mixed, Pourable Sealer has a pot life of 30 minutes.
Note: Part B (1 pint can) may be pressurized - open container slowly.

One gallon of Pourable Sealer contains 3,785 cc for filling Pourable Sealer pockets 3,275 cc should be used to determine gallons required. One gallon of Pourable Sealer will cover 5.8 m of cold tie-in 150 mm wide on a smooth surface. (This coverage will vary according to the roughness of the built-up roof surface.)

1. Review the applicable Material Safety Data Sheet for complete safety information prior to use.
2. Avoid breathing vapors. Keep container closed when not in use. Use with adequate ventilation. If inhaled, remove to fresh air. If not breathing, perform artificial respiration. If breathing is difficult, give oxygen. Call a physician immediately.
3. If swallowed, DO NOT INDUCE VOMITING. Call a physician immediately.
4. Avoid contact with eyes. Safety glasses or goggles are recommended. If splashed in eyes, immediately flush eyes with plenty of clean water for at least 15 minutes. Contact a physician immediately.
5. Avoid contact with skin. Wash hands thoroughly after handling. In case of contact with skin, thoroughly wash affected area with soap and water.
Note: Carlisle's special solvent resistant Hycron gloves are recommended to be worn when using this
product to protect hands from irritating ingredients and from staining.
6. Do not thin Pourable Sealer. Thinning will affect performance.
7. Shelf life is based on storage in original, unopened or undamaged containers at temperatures ranging from 15 ºC to 26 ºC. Should the Pourable Sealer be exposed to lower temperatures, restore to room temperature prior to use.
8. Coverage rates are average and may vary due to conditions of the job site.
9. Avoid contact of Pourable Sealer to other than rubber surfaces. Staining will occur.
10. KEEP OUT OF THE REACH OF CHILDREN.